Cisco D9854 Installation And Operation Manual page 181

MPEGoIP Output
Null Pkts
Null Rate (Mbps)
Protocol
Dest
Src Port
Dest Port
SAP Dest
SAP String
Output Mode
Output Mode
No Output
Passthrough
Service Chans Only
MAP Passthrough
MAP Svc Chans
Only
Full DPM Control
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
Status
Displays whether to insert null packets in the output
stream (Yes or No).
The null packet rate, in Mbps.
The transport protocol used for the output stream
(RTP or UDP).
The multicast destination IP address. The field
displays a range from 0 to 255, in the format
###.###.###.###.
The source UDP port number, in the range from 1 to
65535.
The destination port number, in the range from 1 to
65535.
The SAP destination IP address. The field displays a
range from 0 to 255, in the format ###.###.###.###.
This is the SAP identifier (ID)/string. It displays up
to 49 characters.
No ASI output will be generated.
The output will be identical to the input. The output
channel will not be modified.
PE/PID remapping options, PSI regeneration and User
Rate are not supported in this mode.
Only service channels will be output.
The output will be identical to the input, except that it
will be generated using the DPM and PID mapping
settings.
Only service channels will be output according to the
DPM and PID mapping settings.
The output will be generated according to the DPM
settings on the DPM: ASI or MOIP1 menus. This is a
manual control setting.
Description
Description
5-17