Cisco D9854 Installation And Operation Manual page 89

Setup Menu: Admin,
ADMIN
Lock Level
Description:
Parameters:
Password
Description:
Old Pwd, New Pwd, Confirm Pwd
Description:
Factory Reset
Description
Parameters:
Clear FWD tables
Description
Parameters:
Reboot
Description:
Parameters:
KB Lock
Description
Parameters:
4021470 Rev D D9854 Advanced Program Receiver Installation and Operation Guide
Continued
Sets the front panel keypad lock level.
0, 1, 2, 3 or 4.
Enter the password to successfully set the current lock level. The
default password for all lock levels is 1234.
To change the password, enter the old password (Old Pwd). Next,
enter the new password (New Pwd, four digits in the range from
0000 to 9999) and re-enter the new password for confirmation
(Confirm Pwd). To change the password, the receiver must be in
Lock Level 0. The default password is 1234.
Select this option to perform a reset of receiver settings back to the
factory set (default) values. A warning message prompts you to
confirm the operation.
Reboot Unit - you are prompted to verify the operation.
Abort or Continue.
Select this option to Clear the Forward Tables, which removes
stored database information applicable to upgraded software
versions. A warning message prompts you to confirm the
operation.
Abort or Continue.
Allows you to reboot the receiver. You will be asked to confirm the
operation.
Select Continue to reboot the receiver or Abort to cancel the
operation.
Sets the front panel keypad lock state.
Enabled or Disabled.
4-27