Cisco D9854 Installation And Operation Manual page 269

Warning
Memory Usage
Secondary
FPGA Code Version Set
Ethernet PHY n
FW: Resource Use
Host
FW: Resource Use
Second
4021470 Rev D
Message Message
Type
Set Excessive (stack/
partition) memory
usage
Clear Normal (stack/
partition) memory
usage
FPGA newer than
SW,
Supported=%02u.%0
2u.%02u.%02u,
Running=%02u.%02u
.%02u.%02u
Clear FPGA code ver OK
Set Link is down.
Clear Connection OK
Set Memory or List Near
Full
Clear Normal Level
Set Memory or List Near
Full
Clear Normal Level
D9854 Advanced Program Receiver Installation and Operation Guide
Cause/Remedy
Cause: Possible software
issue.
Remedy: Clear warnings,
reset the unit, and notify
customer service if the
problem persists.
Cause: FPGA version is
newer than the software
can support.
Remedy: Clear warnings,
reset the unit, and notify
customer service if the
problem persists.
Cause: No ethernet cable
connected, faulty cabling,
multiple devices sharing
MAC address on same IP
segment, or possible HW
issue.
Remedy: Check cabling,
check MAC addresses,
clear warnings, reset the
unit, and notify customer
service if the problem
persists.
Cause: Possible software
issue.
Remedy: Clear warnings,
reset the unit, and notify
customer service if the
problem persists.
Cause: Possible software
issue.
Remedy: Clear warnings,
reset the unit, and notify
customer service if the
problem persists.
Description
Software exceeding
allowable memory
usage.
Software indicates
FPGA version is
newer than it can
support.
Ethernet MAC PHY
device is attempting
to reconnect to
external devices.
Software exceeding
allowable usage of
internal constructs.
Software exceeding
allowable usage of
internal constructs.
6-21