Cisco D9854 Installation And Operation Manual page 140

Setup Menu: Outputs: TS Out: DPM,
PSI Rate
Description:
Parameters:
Service ID
Description:
Parameters:
4-78 Model D9854 Advanced Program Receiver Installation and Operation Guide
Continued
This selects the DPM regeneration rate. This applies the PowerVu
rates (consistent with the uplink). This parameter is only used if
Remapping Control is set None.
Auto, MPEG Min or SA Std.
PSI Rate
Auto
MPEG Min
SA Std
This parameter specifies whether the receiver should always
generate PSI tables for the Mapped PE even if the selected input
channel is not available, or for only valid service channels/IDs.
Valid Ch, All Ch.
Svc ID
Valid Ch
All Ch
Description
Matches the generated PSI tables' output
rate as the incoming rate.
Transmits the generated PSI tables on the
longest intervals that are allowed by MPEG
standard.
Transmits the generated PSI tables based on
PowerVu standard intervals.
Description
Only transmits the PSI tables for the
mapped program if the program exists on
the input stream.
Transmits the PSI tables for the mapped
program even if the program does not exist
in the input stream.
All Ch is only valid if the PAT, NIT, SDT
and PMT are set to Regenerate.
4021470 Rev D