Setting Up Backup Restore - Cisco D9854 Installation And Operation Manual

Setting up Backup Restore

To Set Up your Backup Restore
Proceed as follows to configure the backup and restore control:
1. From the user interface of the D9854, click the System tab and then Backup
Restore Setup icon from the sub-page.
Note: You must have access to an FTP Server (e.g. WinFTP) on a network or a local
PC before you can setup backup/restore controls.
2. Type the File Name of the backup/restore file. You can enter up to 31
characters.
3. Set the FTP Server IP Address of the FTP server used to restore the backup/
restore file. The address is up to 12 characters in length (e.g. 171.300.100.200 and
in the range from 0 to 255.
4. Set the FTP port of the FTP server used to store the backup/restore file. You can
enter a port number in the range from 1 to 65535.
5. Set the FTP Username and Password to access the FTP server.
Note: The FTP Password is not retained in the receiver. You must re-enter the
password before initiating the backup or restore operation.
6. Select the backup data sets (Backup Type) to be included in the backup/restore
file. The following table lists the backup files and their descriptions:
Standard
Extended
5-68 Model D9854 Advanced Program Receiver Installation and Operation Guide
Status
Select Standard to save user settings to the backup
file.
Select Extended to save user settings and tuning
information to the backup file.
Description
4021470 Rev D