Setting The Dpm Mode - Cisco D9824 Installation And Configuration Manual

Setting the DPM Mode

A program can be set to one of three Digital Program Mapping (DPM) modes, either
Drop, Pass or Map respectively. For more information, see TS Out - DPM (on page
111) .
LCD Setting
Drop
Pass
Map
1 Press MENU to display the Main Menu.
2 Press
3 Press
4 Press
5 Press
6 Press SELECT to access the Global menu.
7 Press SELECT to choose ASI for Resync All. Press
continue.
8 Press MENU. Press
"InCh" and "OutCh" programs.
9 Press
action for the PID associated with the PE. Press SELECT. Press APPLY. Press
SELECT to save the changes.
10 Press MENU six times to return to the start-up screen.
Description
Removes the service and its associated PMT reference
from the transport output.
Permits the source content and PMT reference to appear
in the transport output with the same references unless
the source material is mapped on another PE.
Provides the flexibility to define all the outgoing PID
numbers for a PE, including those not currently on
transmission.
to move to the Setup menu. Press SELECT.
five times to move to the Outputs menu. Press SELECT.
to move to the TS Out menu. Press SELECT.
to move to the DPM menu. Press SELECT.
to move to the ASI menu. Press SELECT. Verify the PE1
three times to choose Act. Press SELECT. Use

Setting the DPM Mode

and then press SELECT to
to select the DPM
17