Configuring The Dpm Asi Details - Cisco D9858 Installation And Configuration Manual

Configuring the DPM ASI Details

Note: The following procedure defines all the available fields. For a typical setup of
the DPM, see Typical set up for Digital Program Mapping (DPM) (on page 219).
Note: After you make any changes, a successfully updated (session open) message
appears. The changes are displayed, but not saved. You must click Apply to save
and apply the changes.
1 From the user interface of the D9858, choose Transport Stream > Digital
Program Mapping under ASI Output. The ASI Digital Program Mapping page
is displayed.
2 For each DPM Program Entry, it displays the input channel number (Chl #) and
channel Name.
There are two channels (PE1 and PE2), with two auxiliary channels (P1A and
P2A). The auxiliary channels automatically tune to the corresponding PE
channels. If the PE is not transcoded, the auxiliary PE is dropped.
Note: The D9858 is available in a single channel (D9858 -1) or a dual channel
configuration. The single channel transcoder (D9858 -1) supports one Program
Entry (PE1) only.
Note: Any changes made to the MOIP DPM values automatically changes the
Mode Status to Edited by User in the MPEG over IP Output page.
Configuring Transport Stream Information
195