Loglevel; Loopback - Trango Systems TrangoLINK APEX 18 User Manual

RELATED

loglevel

SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
RELATED

loopback

SYNTAX
DEFAULT VALUE
DESCRIPTION
TrangoLINK Apex™ 18 User Manual Rev. 1.0
Mse,rssi
loglevel <0-2>
where 0: Setting
1: Event
2: Status/Statistics
Default 0 1
This command is used to set required log levels for
system logging. The log level needs to be set for each
activity to be monitored. Once the loglevels are set, the
logs can be monitored through the "syslog" command
E.g.: Setting the loglevel to 2 will only log Status/Stats.
The loglevel needs to be set to "loglevel 0 1 2" to monitor
all logs
To set the loglevel to monitor all logs
(trango-config)# loglevel 0 1 2
Syslog level = 0 1 2
syslog
loopback <off | dig | if | rf_gen | rf_refl>
Off
This command is to set the loopback mode.
Digital and If loopback doesn't require a link. It use to
isolate problems on the ADUC/IF only.
Opmode ON is required for the IF loopback mode.
Section: Appendix A - Command Set Summary Page 95