EXAMPLE
RELATED
syslog
SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
RELATED
targetrssi
SYNTAX
TrangoLINK Apex™ 18 User Manual Rev. 1.0
in the failover (1+1) setup and N/A for 1+0 setup
On detecting the Standby unit the Active unit
synchronized the current system setting with the Standby
unit.
To display the current synchronization state
(trango-config)# sync_state
Sync State: Synchronized
Failover, sync
Syslog <clear>
N/A
Syslog command is used to display system event log. All
the configuration changes and errors are logged.
The system log is a circular buffer and old entries will be
deleted once the buffer becomes full. The buffer can have
1000 entries.
Syslog clear, is used to clear the log buffer.
To display the current system log
(trango-config)# syslog
Current 0:01:08:36.120
0> 0:01:08:33.440 [1] [ATTN] eth_set_port_speed: port 0
speed=1000
N/A
targetrssi <value>
Value = -88 to –25 dBm
Section: Appendix A - Command Set Summary
Page 110