Command Line Interface - Trango Systems TrangoLINK APEX 18 User Manual

Command Line Interface

All typical radio functions can be managed via the browser interface, but the Command
Line Interface (CLI) has functionality that facilitates installation. The Command Line
Interface has 3 modes View, Config, and Debug. Logging into the radio via Command
Line Interface is covered here briefly, and a complete listing of all CLI commands is
provided in Appendix A - Command Line Interface.
Launch Telnet
Open a command prompt (DOS) session on your PC (Windows® Start icon and select
"Run"). Open a Telnet session by typing:
telnet [ip address of radio]
Example:
C:>telnet 192.168.100.100
Welcome to Trango-Link APEX Command Line Interface
trango login: admin
Password:
Trango Broadband Wireless:
TrangoLink APEX Command Line Interface v1.0
(trango-view)#
You will be prompted for a login and password. Type in the login and password and
press enter.
To terminate a CLI session (Telnet or Console) simply close the session window. There
is no exit or quit command. This is an intentional security feature.
The Command Line Interface has 3 levels of access. The first level is a view mode
(read-only). The second level is the configuration level (read/write). The last level is the
debug level. Debug is only available through the config mode.
Config Mode: Users can enter this mode by typing in the command "config" from the
view mode. They will be prompted for a password and after successful authentication
users enters the Config mode. All configuration settings can be changed here.
Any command entered without any parameters returns the current configured values
similar to "view" mode.
Configuration changes are applied immediately and don't require any reboot. The only
configuration change that requires a reboot is changing the channel width. If you
change the channel width, save your settings and then reboot. Changing the
modulation but leaving the channel width alone does not require a reboot.
TrangoLINK Apex™ 18 User Manual Rev. 1.0 Section: Chapter 2 - Getting Started Page 23