debug
SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
RELATED
default_opmode
SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
RELATED
TrangoLINK Apex™ 18 User Manual Rev. 1.0
debug
N/A
debug command is used to logout from the current node
to the debug prompt. This is only allowed in the
configuration node, not view node
To switch from "trango-config" to debug prompt
(trango-config)# debug
debug>
cli, config, exit
Default_opmode <on | off>
Off
Default opmode command is used to set the default
operational mode. If enabled the radio will be set to
"opmode on" after power on.
Opmode settings are dependent upon "default_opmode"
after power up.
Set default_opmode on
(trango-config)# default_opmode on
Default Opmode: on
To view current default opmode:
(trango-config)# default_opmode
Default Opmode: off
Opmode
Section: Appendix A - Command Set Summary
Page 87