Cos - Trango Systems TrangoLINK APEX 18 User Manual

EXAMPLE
RELATED

cos

SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
TrangoLINK Apex™ 18 User Manual Rev. 1.0
0: fpga
1: linux sys_os_xxx
2: rootfs
3. pic
4. aduc
Upgrade FPGA image
Enable tftpd on the radio
(trango-config)#tftpd on
Transfer the image from PC(windows/linux)
C:\>tftp –I <IP Address of Radio> PUT sys_fpga_xxxx
Issue the upgrade command on the radio
(trango-config)# bootimage upgrade 0
Wait for the completion and the reboot
(trango-config)# reboot
version, tftpd, reboot
Cos <priority> <queue>
Default Mappings are as shown below
Priority 0: COS Queue = 0
Priority 1: COS Queue = 0
Priority 2: COS Queue = 1
Priority 3: COS Queue = 1
Priority 4: COS Queue = 2
Priority 5: COS Queue = 2
Priority 6: COS Queue = 3
Priority 7: COS Queue = 3
This command is used to map the priority of the incoming
packet to one of the 4 CoS queues. The traffic class of the
incoming packet is mapped 1:1 to the 8 priorities.
The scheduling is strict priority with
COSQ3> COSQ2> COSQ1 > COSQ0
To map priority 6 to CoS queue 1
(trango-config)# cos 6 1
Section: Appendix A - Command Set Summary
sys_fpga_xxx
sys_fw_xxx
sys_pic_xxx
sys_rfm.bin
Page 84