Alignment_Mode; Atpc - Trango Systems TrangoLINK APEX 18 User Manual

alignment_mode

SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
RELATED

atpc

SYNTAX
DEFAULT VALUE
DESCRIPTION
TrangoLINK Apex™ 18 User Manual Rev. 1.0
alignment_mode < on | off >
Off
Alignment mode is used during initial antenna alignment.
When enabled it display the RSSI on the Apex Unit Led at
a higher rate (5/sec) than during normal operation.
ATPC is disabled during alignment_mode. RSSILED
should be ON for alignment_mode
It is recommended to disable alignment_mode during
normal operation.
Turn on the alignment_mode
(trango-config)# alignment_mode on
alignment_mode: on
Check current alignment mode setting
(trango-config)# alignment_mode
alignment mode: on
rssiled, targetrssi
atpc <on | off>
Off
Used to enable/disable ATPC
ATPC is used to automatically adjust the remote end
Apex transmit power in order to maintain the desired level
of RSSI (targetrssi) at the local end.
ATPC should be configured on both the radios. If one end
has ATPC on and the other end has ATPC off, then ATPC
will not work.
User cannot change the power when ATPC in turned on.
The system will adjust the power automatically based on
Section: Appendix A - Command Set Summary Page 80