RPS – Rapid Port Shutdown is
o Disabled ("Off") – The unit will not shut down the GigE/SFP when the
wireless link is lost.
o Enabled ("On") – The unit will shut down the GigE/SFP port when the
wireless link is lost. The remote end will also be notified of the port
shutdown.
RSSI LED- Receive Signal Strength Indicator is
o Disabled ("Off") - The RSSI LED is off and does not display any RSSI
values.
o Enabled ("On") – The RSSI LED will display the RSSI values.
Smart Mode- Internal VLan port mapping is
o Disabled ("Off") – There is no internal VLan port mapping
o Enabled ("On") – Internal VLan port mapping between GE1 and SFP ports
keep traffic separate. Smart Mode must be enabled to support IBM.
SNMP Trap – Simple Network Management Protocol Trap
o Disabled ("Off") - The unit will generate no SNMP Trap messages.
o Enabled ("On") – SNMP Trap messages will be sent the IP destination
configured.
TFTPD – Trivial file transfer protocol daemon is
o Disabled ("Off") - The unit will not accept TFTP file requests.
o Enabled ("On") – The unit will accept TFTP file requests so that the unit
can be upgraded.
Telnetd – Telnet daemon is
o Disabled ("Off") - The unit will not accept Telnet session requests.
o Enabled ("On") – The unit will accept Telnet session requests so that the
unit can be managed via Telnet.
TrangoLINK Apex™ 18 User Manual Rev. 1.0
Section: Chapter 3 - Configuration
Page 30
Need help?
Do you have a question about the TrangoLINK APEX 18 and is the answer not in the manual?
Questions and answers