Atpc_Step; Ber - Trango Systems TrangoLINK APEX 18 User Manual

atpc_step

SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
RELATED

ber

SYNTAX
DEFAULT VALUE
DESCRIPTION
TrangoLINK Apex™ 18 User Manual Rev. 1.0
atpc_step <range>
where range = 1-5dB
1dB
atpc step size controls the Apex power change size during
ATPC operation. The transmit power is changed in step
size on the Apex, unless the maxatcpower or 0 is
reached.
Set the atpc step size to 2
(trango-config)# atpc_step 2
ATPC step size: 2 dB
SUCCESS
atpc, atpc_max_power
ber <duration>
Duration = 1-99sec
Duration = 1
ber command is similar to the "linktest" with internal data
source ONLY. It can be used to test the current link
status and can be used to monitor the link, based on the
specified duration. CLI prompt will not be accessible while
linktest is running
The ber shows the following in the output
Lock: Radio Lock Status
1: if all modem locks are locked
0: if any lock is unlocked
RSSI: The current RSSI value
MSE: The current MSE value
BER : The instantaneous BER value (1sec interval)
Txprofile: The current Tx modulation
Section: Appendix A - Command Set Summary Page 82