Snmptrap; Speed - Trango Systems TrangoLINK APEX 18 User Manual

snmptrap

SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
RELATED

speed

SYNTAX
DEFAULT VALUE
DESCRIPTION
TrangoLINK Apex™ 18 User Manual Rev. 1.0
Snmptrap <on | off>
Off
Snmptrap command is used to enable/disable sending of
the traps from the radio.
Snmpd must be ON for snmptrap to be ON and trapip
should be configured correctly.
Set snmptrap ON
(trango-config)# snmptrap on
snmptrap: on
SUCCESS
snmpd, trapip, ipconfig
Speed <channel_bw> <modulation>
Channel_bw = <0-5>
0 = 10, 1 = 20, 2 = 28, 3 = 40, 4 = 50, 5 = 80
modulation: qpsk | qam16 | qam32 | qam64 | qam128
|qam256
Channel_bw = 5
Modulation = qpsk
Speed command is used to set the required modulation
and channel bandwidth on the modem. The set speed in
Mbps is shown in the output
Section: Appendix A - Command Set Summary Page 105