Polarization of 1+1 Coupler
The 1+1 mount ships with a vertical polarized coupler. In order to change the polarization
to horizontal the vertical couple must be replaced with a horizontal coupler. (Figure 23) This
coupler has a "twist" transition so it will look slightly different than the coupler that connects to
the Apex. The 1+1 coupler also has 2 slightly offset screw holes to ensure proper installation
orientation.
Figure 23: Installing Twist Transition on1+1 Coupler
The vertical and horizontal couplers have differences in the waveguide as shown in
Figure 24.
Figure 24: H and V Transitions
TrangoLINK Apex™ 18 User Manual Rev. 1.0
Section: Chapter 4 - Deployment & Installation
Page 50