Config Mode - Trango Systems TrangoLINK APEX 18 User Manual

status
sync_state
sysinfo
syslog
targetrssi
telnetd
temp
tftpd
trapip
uptime
utype
version

Config Mode

Users can enter this mode by typing in the command "config" from the view mode. They
will be prompted for a password and after successful authentication users enters the
config mode. All configuration settings can be changed here.
• All the commands entered without any parameters returns the current configured
values and are similar to "view" mode.
• All configuration changes are applied immediately and don't require any reboot
(except "speed" in which the settings are applied immediately, but it does require
reboot after save).
• All configuration changes have to be saved in order to be persistent across
reboot. A single "save" command will save all configuration changes
• Users can go back to the "view" mode by typing in the command exit
Command List in Config Mode
CLI
acm
enable
mse_de
mse_im
alignment_mode
atpc
atpc_max_power
atpc_step
TrangoLINK Apex™ 18 User Manual Rev. 1.0
Display status for different device and ports
Display current synchronization state
Display system information
Display system event log
Display target rssi value
Display telnet daemon (telnetd) status
Display current system temperature
Display tftp server (tftpd) status
Display SNMP Trap IP configuration
Display system uptime
Display unit type
Display system software version
Ranges
<mod>
on/off
<mse value>
<mse value>
on/off
on/off
0-20
<1-4> dB
Section: Appendix A - Command Set Summary
Default Value
N/A
Off
Depending on modulation
Depending on modulation
Off
Off
17
1dB
Page 73