Trango Systems TrangoLINK APEX 18 User Manual page 31

o Enabled ("On") – The RSSI LED on the ODU is updated 5 times every
second and the following settings are disabled ATPC and ODU Rx AGC
ATPC – Controls whether ATPC is
o Disabled ("Off") - the ODU delivers the maximum transmit power as
configured. (a function of FCC license limitations for bandwidth and
transmit power, and equipment design limitations determined by data
modulation, or
o Enabled ("On") - the ODU will vary the output power under control of the
far end radio to maintain Target RSSI. ATPC must be enabled on both
sides of the link to be functional.
Default Opmode – Default Operation Mode is
o Disabled ("Off") - The unit will be in Opmode off upon startup.
o Enabled ("On") – The unit will go into Opmode on upon startup.
Failover – When Failover settings is:
o Disabled ("Off") – The setting has no effect.
o Enabled ("On") – 1+1 failover is enabled and the Status LED on the IDU
will start to blink. Failover needs to be enabled on both sides of the link to
be functional.
HTTPD – The Hyper-text transfer protocol daemon is
o Disabled ("Off") - The web browser interface will be disabled.
o Enabled ("On") – The web browser interface is enabled.
IBM – In-Band Management feature
o Disabled ("Off") – Management can only be done via out of band
management port.
o Enabled ("On") – Management can now be done via out of band
management and in band management.
o The default IBM port is copper. This setting can be changed to the fiber
port and requires a reboot for settings to take effect. Current IBM port
settings/status is only available via CLI and will be added to the HTML
interface in a future release.
Opmode – Operation Mode is
o Disabled ("Off") - The unit is accessible but will not transmit RF.
o Enabled ("On") – The unit will transmit to establish a link.
TrangoLINK Apex™ 18 User Manual Rev. 1.0 Section: Chapter 3 - Configuration Page 29