Ipconfig - Trango Systems TrangoLINK APEX 18 User Manual

EXAMPLE
RELATED

ipconfig

SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
RELATED
TrangoLINK Apex™ 18 User Manual Rev. 1.0
To disable ibm
(trango-config)# ibm enable off
IBM enable: off
Check current IBM configuration
(trango-config)# ibm
IBM IP address: 10.10.10.1
Inband management: on
IBM vlan ID: 3
Ipconfig,
Ipconfig <IP address> <Subnet mask> <Gateway IP>
IP address: 192.168.100.100
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.100.100
This command is used to set IP address, subnet mask
and default gateway for the management port of the
system. All three parameter must be present. The
system MAC address can be displayed via this command.
The change takes place effect immediately.
To set IP configuration:
(trango-config)# ipconfig 10.8.1.203 255.255.255.0 10.8.1.1
IP Address: 10.8.1.203
Subnet Mask: 255.255.255.0
Gateway IP: 10.8.1.1
ETH0 MAC: 00:01:DE:00:05:07
SUCCESS
To view current IP configuration:
(trango-config)# ipconfig
IP Address: 10.8.1.203
Subnet Mask: 255.255.255.0
Gateway IP: 10.8.1.1
ETH0 MAC: 00:01:DE:00:05:07
trapip, license
Section: Appendix A - Command Set Summary Page 92