Bootimage - Trango Systems TrangoLINK APEX 18 User Manual

bootimage

SYNTAX
DEFAULT VALUE
DESCRIPTION
TrangoLINK Apex™ 18 User Manual Rev. 1.0
Rx profile: The current Rx modulation
bootimage <upgrade | toggle>
bootimage upgrade <0-4>
0: fpga
1: linux
2: rootfs
3. pic
4. aduc
bootimage <toggle
>
N/A
Bootimage is used to upgrade the required software
images on the radio, after the image is transferred on the
radio via tftp.
Toggle is used to switch to the alternate software image
stored in the flash. The Apex radio is capable of storing 2
complete set of images in the flash. See "version"
command.
A reboot of the radio is required to load the new image
after upgrade. If upgrading multiple images at a time
(0,1,2,3 etc) it is not required to issue reboot after each
upgrade. A single reboot can be issued after all the
images have been successfully upgraded, to reduce the
downtime.
The upgrade time varies depending upon the images and
the size of the image. The progress of the upgrade is
indicated to dots .....and the result is indicated by
SUCCESS/FAILURE.
Make sure the file names of the images to be transferred
(via tftp) are in the following format.
Section: Appendix A - Command Set Summary Page 83