Debug Mode - Trango Systems TrangoLINK APEX 18 User Manual

Debug Mode

This node is additional management port related settings and users enter the debug
mode, by typing in the "Exit" command from the view mode. Users can reenter the view
node by entering the command "cli"
Debug and View mode share the same password and the password can be changed
from the debug node only.
Command List in Debug Mode
Cli
Exit
Help
tg_reboot
tg_powercycle
Ping
Route
Ssh
Syslog
telnet
TrangoLINK Apex™ 18 User Manual Rev. 1.0
Used to Enter the CLI (trango-view) node
Logout of the system
Display list of commands in the debug node
Reboot the system
Power cycle the system
<ip address> ping network hosts
N/A Display the current system routing table
<ip address> ssh into another host
Display current system log
<ip address> telnet into another host
Section: Appendix A - Command Set Summary Page 77