Reset - Trango Systems TrangoLINK APEX 18 User Manual

RELATED

reset

SYNTAX
DEFAULT VALUE
DESCRIPTION
EXAMPLE
RELATED
rps_enable
SYNTAX
DEFAULT VALUE
DESCRIPTION
TrangoLINK Apex™ 18 User Manual Rev. 1.0
SUCESS
Reset
reset
N/A
Reset is used to restore factory default settings.
All currently configured settings will be lost. Reboot of the
radio is required for the new settings to take effect.
The command doesn't ask for any confirmation.
User caution is required before reboot.
Restore factory default settings
(trango-config)# reset
Default setting restored. Issue reboot command for the default to take
effect
SUCCESS
Reboot
rps_enable < on | off>
Default: Off
This command is used to configure Rapid Port Shutdown
(RPS) functionality. The RPS setting needs to be the
same on both side of the link for proper operation.
If the RPS is enabled the dataports (GigE) on both side of
the link are immediately shutdown in the event of a link
loss in order to provide a fast switchover mechanism to
the external routers and switches.
Section: Appendix A - Command Set Summary Page 101