Figure 20: 1+1 Coupler And Latches; Figure 21: 1+1 Coupler Installed On Antenna - Trango Systems TrangoLINK APEX 18 User Manual

Figure 20: 1+1 Coupler and Latches

Once the 1+1 coupler has been installed (Figure 21) the radios can be mounted to the
1+1 coupler. The polarization for the 1+1 mount is determined by the transition between
the mount and the antenna. The Apex radios needs to be mounted in the H-Pol position
on the 1+1 mount as the coupler determines polarity. Please order your correct polarity.

Figure 21: 1+1 Coupler Installed on Antenna

Both Apex units must be mounted in the same position with the LED Panel on the
bottom right side as shown in Figure 22 regardless of desired RF polarization.
TrangoLINK Apex™ 18 User Manual Rev. 1.0 Section: Chapter 4 - Deployment & Installation Page 48