Log - Novatel WAAS G-III User Manual

Chapter 4

4.4.14 LOG

You can log many different types of data using several different methods of triggering the log events. See
Chapter 5, Data Logs starting on Page 85 for further information and a complete list of data log structures.
To remove a log use the UNLOG command. To remove all logs, use the UNLOGALL command.
The period parameter is only valid when the ONTIME trigger is being used.
Valid States:
Valid Modes:
Acceptable Ports:
Syntax:
LOG [port] message [trigger] [period]
Example:
LOG ICOM1 measurementdatab ontime 1
LOG ICOM1 rxcommandsb
LOG versionb
LOG agcinfob once
Field Field Name
1 port
2 message
3 trigger
4 period
60
Configuration, Operational, Maintenance
Normal, Failed
Data
Description
The communication port used to output the data.
[Optional].
If a port is not specified, the requested logs are output
on the port from which the command was issued.
The message type.
The trigger condition.
Select once to output the log only once.
Select onnew to output the log immediately and each
time it is updated.
Select ontime to output the log at the rate specified in
the period field.
[Optional]
If the trigger condition is not specified, a default of
once is used.
Number of seconds between logs
[Optional]
If the trigger condition is ontime, and the period is not
specified, a default of 1 is used.
WAAS G-III Reference Receiver User Manual Rev 1
Commands
Range Precision
ICOM1
N/A
ICOM2
See Table 24
N/A
on Page 61
once
onnew N/A
ontime
1-1000 Int