Ipconfig - Novatel WAAS G-III User Manual

Commands

4.4.13 IPCONFIG

This command configures the IP address, netmask and gateway for an Ethernet port.
 Commands received on the Data port (J02) are applicable only to the Monitor port (J03).
Attempts to change the Data port from the Data port are rejected.
An ICOMCONFIG command is required to enable the ICOM port for the Ethernet interface
after changing the IP address from 0.0.0.0 to a non 0.0.0.0 address.
The IPCONFIG commands also queries the current IP configuration of the Ethernet port.
Valid States:
Valid Modes:
Acceptable Ports:
Syntax:
IPCONFIG interface mode [IP address] [netmask] [gateway]
Example:
IPCONFIG ETHB STATIC 10.10.0.10 255.255.255.0
The following syntax has no effect on the receiver configuration. Instead, the command response contains the
current IP configuration.
Alternate Syntax:
IPCONFIG interface
Example:
IPCONFIG ETHA
<INFO:IPCONFIG ETHA STATIC 192.168.1.101 255.255.255.0 0.0.0.0
Field Field Name
1 interface
2 mode
3 IP address
4 netmask
5 gateway
a. APIPA IP address block 169.254.0.0/16 not supported.
WAAS G-III Reference Receiver User Manual Rev 1
Configuration, Maintenance
Normal, Failed
Data, Maintenance
Description
The name of the Ethernet interface.
The IP addressing mode of the Ethernet port.
The IP address of the Ethernet port.
Enter in the format: xxx.xxx.xxx.xxx
[Optional]
This field defaults to 0.0.0.0 if not specified.
The netmask of the Ethernet port.
Enter in the format: xxx.xxx.xxx.xxx
[Optional]
This field defaults to 255.255.255.0 if not specified.
The IP address of the gateway.
Enter in the format: xxx.xxx.xxx.xxx
[Optional]
This field defaults to 0.0.0.0 if not specified.
Chapter 4
Range Precision
etha
N/A
ethb
static N/A
a
N/A
IPv4 address
IPv4 netmask N/A
IPv4 address N/A
59