Ethconfig - Novatel WAAS G-III User Manual

Commands

4.4.10 ETHCONFIG

This command configures the physical layer Ethernet settings.

Commands received on the Data port (J02) are applicable only to the Monitor port (J03).
Attempts to change the Data port from the Data port are rejected.
The ETHCONFIG command also queries the current Ethernet settings.
Valid States:
Valid Modes:
Acceptable Ports:
Syntax:
ETHCONFIG interface speed duplex portpolarity
Example:
ETHCONFIG ETHB AUTO AUTO AUTO
ETHCONFIG ETHA 100 HALF MDI
The following alternate syntax has no effect on the receiver configuration. Instead, the command response
contains the current Ethernet configuration.
Alternate Syntax:
ETHCONFIG interface
Example:
ETHCONFIG ETHA
<INFO:ETHCONFIG ETHA 100 FULL MDI
Field Field Name
1
interface
b
2
speed
b
3
duplex
4 portpolarity
a. etha corresponds to the Data port.
ethb corresponds to the Monitor port.
b. If either the speed or duplex field is set to auto, both fields must be set to auto.
WAAS G-III Reference Receiver User Manual Rev 1
Configuration, Maintenance
Normal, Failed
Data, Maintenance
a
Name of the Ethernet interface
Ethernet speed (Mbits/second)
Ethernet duplex state
Ethernet port polarity
Description
Chapter 4
Range Precision
etha
N/A
ethb
auto
10 N/A
100
auto
half N/A
full
auto
mdi N/A
mdix
55