Novatel WAAS G-III User Manual page 42

Reference receiver
Table of Contents

Advertisement

Chapter 4
Command Name
CLEAREXCEPTIONDATA
CORRSPACING
DLLBW
ECUTOFF
ETHCONFIG
FIX
ICOMCONFIG
IPCONFIG
LOG
NSCODE
PLLDYNAMIC
PULSEBLANKING
RESET
RESTORE
RFATTEN
RFIFTEMP
SAVEPORTS
SOFTLOADCOMMIT
SOFTLOADFINALIZE
SOFTLOADRESET
SOFTLOADSREC
SYSPROFILE
42
Table 22: Command Summary (continued)
Description
Clears any previously saved exception data.
Changes the early minus late discriminator
locations for the specified signal channel.
Configures the DLL filter bandwidth.
Sets the elevation cut-off angle for all SV
channels assigned to track satellites.
Configures the physical layer Ethernet
settings.
Sets the position parameters for the G-III
Reference Receiver.
Configures the virtual COM port, UDP port
and peer IP addresses.
Configures the IP address, netmask and
gateway for an Ethernet port.
Configures log collection.
Specifies a non-standard code to be used in
signal tracking.
Sets the parameters associated with
dynamic PLL tracking.
Sets the pulse blanking values.
Performs a hardware reset of the receiver.
Restores all Ethernet configurations to their
default values.
Changes the attenuation value on the
software adjustable attenuator controlling
the received RF signal.
Enables or disables RF/IF temperature
control.
Saves the Ethernet, IP and ICOM
configuration to NVM.
Saves the firmware image from the RAM
buffer to flash memory.
Finalizes the firmware download by erasing
the old firmware.
Starts the firmware loading process.
Sends an S-Record format data block to a
RAM buffer on the G-III Reference Receiver.
Displays the system profile information.
CLEAREXCEPTIONDATA
CORRSPACING signal svChan
spacing
DLLBW signal bw
ECUTOFF angle
ETHCONFIG interface speed
duplex portpolarity
FIX type [latitude longitude
height]
ICOMCONFIG port protocol
[endpoint] [BindInterface]
IPCONFIG interface mode [IP
address] [netmask] [gateway]
LOG [port] message [trigger]
[period]
NSCODE signal component prn
chippingrate length
nonstandard
PLLDYNAMIC signal setting
lowbw [highbw cno PLLerror
timethreshold]
PULSEBLANKING frequency
threshold exttime
RESET
RESTORE
RFATTEN setting
RFIFTEMP setting
SAVEPORTS
SOFTLOADCOMMIT
SOFTLOADFINALIZE
SOFTLOADRESET
SOFTLOADSREC s-records
SYSPROFILE
WAAS G-III Reference Receiver User Manual Rev 1
Commands
Syntax

Advertisement

Table of Contents
loading

Table of Contents