Table of Contents
Advertisement
Commands
Logs with an allowed trigger of ONNEW may also be logged with a trigger of ONCE. However,
only one log will be output, regardless of the number of related logs for each tracked signal. This
means that if 5 signals are tracked, only one of those signals will be reported for frame logs.
Although the LOG command is accepted in the Configuration and Maintenance states, some
logs (e.g. MEASUREMENTDATAB) are only output in the Operational state. If a LOG
command is provided for one of these logs in the Configuration state, the command is accepted
and saved but the log will not begin to be output until the receiver is transitioned to the
Operational state.
WAAS G-III Reference Receiver User Manual Rev 1
Table 24: Message Type
Message Type
AGCINFOB
ALLSQMIB
ALLSQMQB
ALMANACB
CARDSTATUSB
CORRDATAB
CORRLOCATIONB
ETHSTATUSB
EXCEPTIONDATAB
FACTORYDATAB
MEASUREMENTDATAB
RANGEB
RAWGPSSUBFRAMEWPB
RAWFRAMEDATAB
RAWWAASFRAMEWPB
RXCOMMANDSB
SATPOSB
SOFTLOADSTATUSB
TIMESOLUTIONB
VERSIONB
Allowed Trigger
ONCE, ONTIME
ONNEW
ONNEW
ONCE, ONNEW
ONCE, ONTIME
ONCE, ONTIME
ONCE, ONTIME, ONNEW
ONCE, ONTIME
ONCE
ONCE, ONTIME
ONCE, ONTIME
ONCE, ONTIME
ONNEW
ONNEW
ONNEW
ONCE, ONTIME
ONCE, ONTIME
ONCE, ONTIME, ONNEW
ONCE, ONTIME
ONCE, ONTIME
Chapter 4
61
Advertisement
Table of Contents
