Functional Listing Of Commands; Communication Commands; Radio Frequency Control Commands; Tracking Control Commands - Novatel WAAS G-III User Manual

Chapter 4
4.2

Functional Listing of Commands

The following tables list the commands by function. See Section 4.4 Command Reference on Page 44 for a
more detailed description of each individual command.
Command
ETHCONFIG
ICOMCONFIG
IPCONFIG
LOG
UNLOG
UNLOGALL
Command
AGCMODE
ANTENNAPOWER
PULSEBLANKING
RFATTEN
RFIFTEMP
Command
ASSIGN
CORRSPACING
DLLBW
ECUTOFF
NSCODE
PLLDYNAMIC
THRESHOLD
TRACKMODE
TRACKTYPE
UNASSIGN
40
Table 16: Communication Commands
Configures the physical layer Ethernet settings.
Configures the virtual COM port, UDP port and peer IP address.
Configures the IP address, netmask and gateway for an Ethernet port.
Configures log collection.
Removes a specified log from logging control.
Removes all logs from logging control.
Table 17: Radio Frequency Control Commands
Configures Automatic Gain Control (AGC) functionality.
Enables or disables electrical power to an active antenna.
Sets the pulse blanking values.
Changes the attenuation value on the software adjustable attenuator
controlling the received RF signal.
Enables or disables RF/IF temperature control.
Table 18: Tracking Control Commands
Assigns a tracking channel to use to search for a satellite.
Changes the early minus late discriminator locations for the specified signal
channel.
Changes the DLL filter bandwidth.
Sets the elevation cut-off angle for all SV channels assigned to track satellites.
Specifies a non-standard code to be used in signal tracking.
Sets the parameters associated with dynamic PLL tracking.
Sets the signal acquisition, steady-state lock signal and cross-correlation
thresholds.
Changes the channel assignment method.
Changes the type of tracking used for a specified channel.
Cancels a previously issued ASSIGN command.
Description
Description
Description
WAAS G-III Reference Receiver User Manual Rev 1
Commands