Command Reference - Novatel WAAS G-III User Manual

Chapter 4
4.4

Command Reference

All syntax strings and command examples given in this section are in the ASCII format. The tables provided
show the fields necessary for all formats unless otherwise noted.

All command strings must be followed by <ENTER>.
Optional fields in a command are indicated by square brackets [ ]. If there are multiple fields within the square
brackets, all of the fields must be specified.
The Format for a field specifies the type value for that field.
Int
Float
Double
ULong
N/A
In the following command descriptions, the state, mode and port required to use the command are listed.
Valid States
Valid Mode
Acceptable Ports
All three of the listed requirements must be met to use the command. If any of the three requirements are not
met, the command will be rejected.
44
Format
The value must be a whole number.
The value has a maximum of 7 significant digits.
The value has a maximum of 15 significant digits.
A 32-bit unsigned integer in the range +0 to +4294967295.
The set string for this field is not case sensitive.
Indicates the states the receiver must be in to use the command.
Indicates mode the receiver must be in to use the command.
Indicates the receiver port to which you must be connected to
use the command.
Type of value needed
WAAS G-III Reference Receiver User Manual Rev 1
Commands