Chanconfig; Channel Configuration Range - Novatel WAAS G-III User Manual

Commands
4.4.4

CHANCONFIG

This command changes the channel configuration of the receiver. This affects the number of channels tracking
GPS signals and the number of channels tracking SBAS signals. This command resets the receiver, causing the
receiver to enter the BOOT state. The channel configuration is saved in non-volatile memory (NVM) and is
used across resets.
This command cannot be cleared, except by issuing another CHANCONFIG command.

Only one option is available for the G-III Reference Receiver. Sending this command to
reconfigure to the same configuration will still result in a reset of the receiver.
Valid States:
Valid Modes:
Acceptable Ports:
Syntax:
CHANCONFIG config
Example:
CHANCONFIG 18GPSALL8GEO
Field Field Name
1 config
Configuration
18GPSALL8GEO
WAAS G-III Reference Receiver User Manual Rev 1
Configuration
Normal
Data
Receiver configuration
Table 23: Channel Configuration Range
18 GPS channels tracking L1 C/A, L1 C, L2 C, L2 P(Y) and L5,
8 L1 C/A SBAS and 8 L5 SBAS
Description
Description
Chapter 4
Range Precision
See Table 23
N/A
49