Reset - Novatel WAAS G-III User Manual

Chapter 4

4.4.18 RESET

This command performs a hardware reset. Following a RESET command, the receiver re-enters the BOOT
state.
Valid States:
Valid Modes:
Acceptable Ports:

When the receiver is in the Operational state, the RESET command can be issued only from the
Data port.
Syntax:
RESET
Example:
RESET
A command response indicating that the RESET command was accepted successfully is output before the
system resets.
68
Maintenance, Configuration, Operational
Normal, Failed
Data, Maintenance
WAAS G-III Reference Receiver User Manual Rev 1
Commands