Icomconfig - Novatel WAAS G-III User Manual

Commands

4.4.12 ICOMCONFIG

This command configures the virtual COM port, UDP port and peer IP address.
The ICOMCONFIG command also queries the current virtual communication port configuration.

Commands received on the Data port (J02) are applicable only to the Monitor port (J03).
Attempts to change the Data port from the Data port are rejected.

ICOMCONFIG configuration depends on the IPCONFIG associated with the BindInterface.
Existing ICOMCONFIG configuration can be impacted by changes of the IPCONFIG
associated with the BindInterface. The scenarios in the following table detail the
ICOMCONFIG configuration change introduced by an IPCONFIG change.
Scenario BindInterface
1 X
2 ETHA
3 ETHA
4 ETHA
5 ETHA
6 ETHB
7 X
Valid States:
Valid Modes:
Acceptable Ports:
Syntax:
ICOMCONFIG port protocol [endpoint] [BindInterface]
Example:
ICOMCONFIG icom2 udp 255.255.255.255:3001 ETHB
ICOMCONFIG icom1 udp :3000 ETHA
ICOMCONFIG icom2 disabled
WAAS G-III Reference Receiver User Manual Rev 1
Gateway IP
X 255.255.255.255
X 0.0.0.0
X Same as BindInterface IP.
Not in same subnet of
0.0.0.0
BindInterface IP.
Not in same subnet of
Not 0.0.0.0
BindInterface IP.
X Subnet broadcast IP.
Not the same as BindInterface
X IP and in the same subnet as
BindInterface IP.
Configuration, Maintenance
Normal, Failed
Data, Maintenance
Peer Host IP
No change.
No change.
DISABLED.
DISABLED.
No Change.
With subnet broadcast IP of the
new BindInterface IP subnet.
No change.
Chapter 4
ICOMCONFIG
Reconfiguration
57