Commands; Entering Commands; Command Settings On Power-Up; Factory Defaults For Commands - Novatel WAAS G-III User Manual

Chapter 4
The G-III Reference Receiver is capable of responding to many different input commands. The commands
offer a wide range of flexibility and can be used to control the following:
• Overall status of the G-III Reference Receiver
• Input and output functions
• Configuration of the G-III Reference Receiver
4.1

Entering Commands

The following rules apply when entering commands:
1. You must enter commands in ASCII format.
2. The commands are not case sensitive. The following examples work the same:
FIX POSITION or fix position
3. All command strings must be followed by one of the following:
• CR (0x0D)
• NL (0x0A)
• CR+NL (0x0D, 0x0A)
If you are manually entering a command, press <ENTER> at end of a command or command
string,
4. Commands are accepted only on the Data and Maintenance ports.
5. The Maintenance port only accepts commands related to Ethernet communications and only
during the Configuration state.
4.1.1

Command Settings on Power-Up

When the G-III Reference Receiver is first powered up, all commands are at the factory default settings.
AGCMODE
ANTENNAPOWER
CHANCONFIG
CORRSPACING
36

Commands

Table 14: Factory Defaults for Commands
Command
L1 auto
L2 auto
L5 auto
off
18GPSALL8GEO
L1geo 18 0.1
L1geo 19 0.1
L1geo 20 0.1
L1geo 21 0.1
L1geo 22 0.1
L1geo 23 0.1
L1geo 24 0.1
L1geo 25 0.1
Parameters
WAAS G-III Reference Receiver User Manual Rev 1