Optional Installation Steps; Check The Ethernet Settings; Data Port Default Settings; Monitor Port Default Settings - Novatel WAAS G-III User Manual

Installation
 Before you connect the Monitor port to a computer or network, make sure the Ethernet settings
for the Monitor port is compatible with the computer or network.
See Section 2.2.1, Check the Ethernet settings on Page 25.
2.2

Optional Installation Steps

In addition to the required connections discussed in the previous sections, other ports on the G-III Reference
Receiver can be used to implement additional functionality.
2.2.1

Check the Ethernet settings

Before you connect the Data or Monitor port to your network, ensure the Ethernet port configuration is
compatible with your network configuration.
The following tables show the default configuration for the Ethernet ports.
WAAS G-III Reference Receiver User Manual Rev 1
Table 5: Data port default settings
Setting
Interface Name
Virtual Port Identifier
Ethernet Speed
Duplex
Port Polarity
Protocol
Endpoint
IP Addressing Mode
IP Address
Netmask
Gateway
Table 6: Monitor port default settings
Setting
Interface Name
Virtual Port Identifier
Ethernet Speed
Duplex
Port Polarity
Protocol
Endpoint
Value
ETHA
ICOM1
100 Mbit/second
Full duplex
MDI
UDP
Host:3000
Static
192.168.0.10
255.255.255.0
0.0.0.0
Value
ETHB
ICOM2
Auto
Auto
Auto
Disabled
-
Chapter 2
25