Command Summary; General Receiver Control Commands; Position Command; Firmware Upgrade Commands - Novatel WAAS G-III User Manual

Commands
Command
CHANCONFIG
CHANGESTATE
CLEAREXCEPTIONDATA
RESET
RESTORE
SAVEPORTS
SYSPROFILE
Command
FIX
Command
SOFTLOADCOMMIT
SOFTLOADFINALIZE
SOFTLOADRESET
SOFTLOADSREC
4.3

Command Summary

The following table shows all of the G-III Reference Receiver commands. See Section 4.4 Command Reference
on Page 44 for a more detailed description of each individual command.
Command Name
AGCMODE
ANTENNAPOWER
ASSIGN
CHANCONFIG
CHANGESTATE
WAAS G-III Reference Receiver User Manual Rev 1
Table 19: General Receiver Control Commands
Changes the channel configuration of the receiver.
Changes the state of the receiver.
Clears any previously saved exception data.
Performs a hardware reset of the receiver.
Restores all Ethernet configurations to their default values.
Saves the Ethernet, IP and ICOM configuration to NVM.
Displays the system profile information.
Table 20: Position Command
Sets the position parameters for the G-III Reference Receiver.
Table 21: Firmware Upgrade Commands
Saves the firmware image from the RAM buffer to flash memory.
Finalizes the firmware download by erasing the old firmware.
Starts the firmware loading process.
Sends an S-Record format data block to a RAM buffer on the G-III Reference
Receiver.
Table 22: Command Summary
Description
Configures Automatic Gain Control (AGC)
functionality.
Enables or disables electrical power to an
active antenna.
Assigns a tracking channel to use to search
for a satellite.
Changes the channel configuration of the
receiver.
Changes the state of the receiver.
Description
Description
Description
Syntax
AGCMODE frequency mode
[pulsewidth modulus]
ANTENNAPOWER flag
ASSIGN svChan [state] [prn
[Doppler window]]
CHANCONFIG config
CHANGESTATE state
Chapter 4
41