Propak6 Security; Administration Password; Ftp Server And Icom Ports; 2.10 Next Steps - Novatel ProPak6 User Manual

Installation
NovAtel Connect is a windows based GUI used to access the receiver's many features without the need
for communications protocol or other special software. The Convert utility is a windows based utility used
to convert between file formats and strips unwanted records for data file compilation.

If using Ethernet, the port needs to be configured prior to use. Refer to Chapter 4,
Ethernet Configuration on page 73 for configuration instructions.
2.9

ProPak6 Security

2.9.1

Administration Password


The Administrator password should be changed prior to using the FTP server or ICOM
ports.
An Administrator password is available to secure FTP and ICOM ports. The default Administrator
password is the Product Serial Number (PSN) of the receiver and the predefined user name is "admin".
An Administrator has read/write access and the ability to change passwords, issue commands, upload
files to the FTP server or upload new firmware.
A password can be up to a maximum of 28 characters/digits. The "admin" user name cannot be changed.
Use the SETADMINPASSWORD command to change the default password.
Refer to the OEM6 Firmware Reference Manual
2.9.2

FTP Server and ICOM Ports

The FTP server is disabled by default. The IPSERVICE FTP_SERVER command is issued to enable or
disable the FTP server port. Refer to Section 3.7.1.5, Remote Retrieval of Logged Data on page 59 for
instructions on enabling the FTP port.
For security purposes, the IPSERVICE SECURE_ICOM command can also be used to enable password
security on the ICOM ports. When security is enabled, the port refuses incoming commands until a valid
User Name and Password are entered using the LOGIN command. Once logged in to an ICOM port, use
the LOGOUT command to sign out of the connection and resecure the port. Refer to Section 3.1.13.1,
Configure COM 1, 2 and 3 on page 42 for further details.
Refer to the OEM6 Firmware Reference Manual
command.

2.10 Next Steps

Once the physical installation is complete and power is applied, various ports and radios need to be
enabled and/or configured. Refer to the upcoming chapters for operation and configuration details.
ProPak6 Installation and Operation User Manual Rev 4
Example:
Label is located on the bottom of the ProPak6
- OM-20000129 for command details.
- OM-20000129 for details on the IPSERVICE
Chapter 2
33