Show Palette; Wireless Status (Optional Wav-Pk) - AMX Wireless Touch Panels (Wave Server) Instruction Manual

Note
The WAV-PK page provides
read-only information about
the Wave-Pack. The only
setting that can be changed is
the SLEEP TIMEOUT value.
Figure 89
WAV-PK page
64 Touch Panel Program Reference

Show palette

Press SHOW PALETTE to open the color palette. Pressing the screen again will cause
you to leave the Show Palette page.

Wireless status (optional WAV-PK)

The WIRELESS STATUS button appears on the Setup page when an AXR-WAVES
Wireless AXlink Virtual Emulator Server is connected to the touch panel. The WAV-
PKM provides wireless two-way RF spread-spectrum touch panel control and
contains a lead-acid rechargeable battery that supplies independent power to the
panel. Refer to the WAVE 2-Way Wireless Accessories and Adapters for Touch Panels
instruction manual for detailed setup information. Press the WIRELESS STATUS
button to open the WAV-PK page shown in Figure 89.
The Wave-Pack page shows the following information:
•
SLEEP TIMEOUT
The minimum time-out is 1 minute and maximum is 120 minutes. When the
touch panel goes to sleep, all communication and battery discharge stops. If
the time-out is set to 5, the panel goes into sleep mode if there is no activity
for 5 minutes. The touch panel automatically wakes up when you touch the
screen for more than 0.5 seconds.
Press the UP and DN buttons to set the sleep time-out.
ViewPoint Wireless Touch Panels