Table of Contents
Advertisement
Figure 101
AUTO ASSIGN button
Figure 102
PAGE PASSWORD button
Note
This numeric password ap-
plies to the touch panel pages
only, and is separate from the
SETUP PASSWORD button
that sets up the numeric
password for access to the
Protected Setup page.
Note
Press and hold for 2 seconds
to enter Calibration mode
Figure 103
CALIBRATE decision button
Note
The crosshair for calibration is
first shown at the top-left
corner of the touch panel
screen.
74
Touch Panel Program Reference
Page password
Press the PAGE PASSWORD button (Figure 102) to open a keypad and assign a
page's numeric password.
If you try to open a password-protected page, the keypad appears, and you must
enter the correct password number to open the new page. The page password range
is 1–5,999.
•
Clears the number in the keypad display.
CLEAR
•
Sets the page password number, closes the keypad, and returns to
ENTER
the Protected Setup page.
Calibrate
Press CALIBRATE to open the CALIBRATE decision button shown in Figure 103 and
reset the vertical and horizontal touch points on the LCD.
•
Starts the calibration process. Carefully press each crosshair that
YES
appears using your finger or dull pointer. When the calibration process is
complete, press the screen to return to the Protected Setup page.
•
Cancels the calibration process.
NO
Power up message
Press POWER UP MESSAGE (Figure 104) to open the keyboard, and enter an ASCII
string to be sent to the Central Controller when the touch panel is powered up. The
Central Controller can be programmed to perform specific operations when the
ViewPoint Wireless Touch Panels
Advertisement
Table of Contents
