Note
The WAV-PKM page provides
information about the Wave-
Pack. The only setting which
can be changed is the SLEEP
TIMEOUT for the touch panel.
Figure 102
WAV-PKM page
Note
The mini touch panels require
different types of battery
packs than the 8.5" and 10.4"
touch panels. The WAV-PKM
and SMT-PKM are made for
the mini touch panels.
Note
All mini-touch panels wake by
pushing the button on the
back of the Mini-WavePack.
66
Touch Panel Program Reference
Show palette
Press SHOW PALETTE to open the color palette. Pressing the screen again will cause
you to leave the Show Palette page.
Wireless status (optional WAV-PKM)
The WIRELESS STATUS button appears on the Setup page when an AXR-WAVES
Wireless AXlink Virtual Emulator Server is connected to the touch panel. The WAV-
PKM provides wireless two-way RF spread-spectrum touch panel control and con-
tains a lead-acid rechargeable battery that supplies independent power to the panel.
Refer to the WAVE 2-Way Wireless Accessories and Adapters for Touch Panels instruction
manual for detailed setup information. Press the WIRELESS STATUS button to open
the WAV-PKM page shown in Figure 102.
The Mini-Wave-Pack page shows the following information:
SLEEP TIMEOUT
The minimum time-out is 1 minute and maximum is 120 minutes. When the
touch panel goes to sleep, all communication and battery discharge stops. If
the time-out is set to 5, the panel goes into sleep mode if there is no activity
for 5 minutes. The touch panel automatically wakes up when you touch the
screen for more than .5 seconds.
Wave-Pak Not Locked/Locked
is connected to the touch panel. Not locked indicates the touch panel is not
communicating with the AXR-WAVES. Locked indicates the touch panel is
Press the UP and DN buttons to set the sleep time-out.
Appears when an optional WAV-PKM
Color Active-Matrix LCD Mini-Touch Panels