Table of Contents
Advertisement
Figure 35
BUTTON BORDER menu
pages
Note
If DEVICE USED is set to 4
and Base Device Number is
128, the Central Controller
recognizes bus devices 128,
129, 130, and 131.
Figure 36
CHANNEL code buttons
Note
The panel will not allow you to
enter a device number greater
than the DEVICE USED
without first displaying a
decision box. This box asks
you to decide whether you
accept the new selection or
default to the previous value.
ViewPoint Wireless Touch Panels
2.
Press 3D RECTANGLE 1 to set the button border to 3D RECTANGLE 1 style and
return to the Button Properties page. The BORDER button in the Button
Properties page changes to show the active border type. In this case, the button
changes to the 3D-rectangle border.
Setting the channel code
The channel buttons that set the device and button channel codes for the touch panels
are shown in Figure 36. Refer to Figure 143 for more information on DEV and CHAN.
Press DEV to open the keypad and set the touch panel's device number.
1.
2.
Enter 1, 2, 3, or 4 in the keypad. The AXCESS software program uses device
codes 1 through 4 to identify the touch panel. Refer to the Touch Panel Program
Reference section for detailed information.
a.
For 1-way ViewPoints, use device number 1 for AMX IR and RF. Use device
numbers 2, 3, and 4 for other manufacturer's IR codes.
Designing Touch Panel Pages
29
Advertisement
Table of Contents
