Function Show Example - AMX MVP-9000i Operation And Reference Manual

System & Panel Options Page (Cont.)
Panel Options (Cont.):
Security:
Orientation:
System Options:
Reset Settings:
Install Firmware:
Undock Panel:
Remove Pages:
Install Pages:
USB Ready:

Function Show Example

Channel Code
Channel Port
Level Port
Channel Code
FIG. 69 Function Show example
MVP-9000i 9" Modero® ViewPoint® Touch Panel with Intercom
• Displays one of three security settings: Standard, Secure, and DoD. Pressing
this button opens a popup window allowing changes to the Security Profile.
NOTE: Refer to the Security Settings section on page 62 for very important
information on using this feature.
• Selects the orientation by which the panel pages are presented: 0° -
Landscape, 90° - Portrait, and 270° - Portrait.
• Deletes all of the current configuration parameters on the panel (including IP
Addresses, Device Number assignments, Passwords, and other presets).
This option invokes a Confirmation dialog, prompting you to confirm your
selection before resetting the panel.
• This button allows you to revert the current firmware to factory default, revert
to the previously installed firmware version, or to install firmware from a
properly formatted USB thumb drive or microSD card.
• Releases the panel from the Table Docking Station (page 11) or the Wall
Docking Station (page 14).
• Removes all TPD4 touch panel pages currently on the panel, including the
pre-installed AMX Demo pages. This option invokes a Confirmation dialog,
prompting you to confirm your selection before removing the panel pages.
• Note that the YES button on the Confirmation dialog is disabled for 5
seconds as additional protection against accidentally resetting the panel or
removing the panel pages.
• Allows uploading of touch panel pages via USB thumb drive or microSD
card. If the panel is not connected to a thumb drive or microSD card, this
button will be blacked out.
• Notes that the panel is ready to accept files via a USB device.
When the Function Show feature is displayed, the Channel Port and Code will appear
in yellow, the Address Port and Code in green, and the Level Port and Channel Code
in purple.
0.20
BUTTON
0,8 0,50
Address Port
Address Code
Protected Setup Pages
61