Device Used; Setup Password; Power Up Page - AMX Wireless Touch Panels (Wave Server) Instruction Manual

Figure 96
DEVICE BASE button
Note
If four devices are used, and
the base address is 128, then
the touch panel will
consecutively use device
numbers 128, 129, 130, and
131.
Figure 97
DEVICE USED button
Figure 98
SETUP PASSWORD button
Warning
If you change the password
number, record the new
number and keep it in a
secure place. If you change
the password, AMX cannot
provide you with the
password.
72 Touch Panel Program Reference

Device used

Press the DEVICE USED button (Figure 97) to open a keypad and set the panel's
device number from 1 through 4. Each device number supports up to 255-channel
code button assignments. The multiple device settings allow you to create up to four
unique touch panel buttons and/or pages. This value is used to determine the
current device being used by the panel.

Setup password

Press the SETUP PASSWORD button (Figure 98) to open a keypad and set the
numeric SETUP password.
The password number range is 1 through 5,999. (Do not use zero.) Do not change the
Setup page password unless you are concerned about unauthorized access to the
touch panel pages.
• Press to clear the number in the keypad display.
CLEAR
•
Press to enter the new password into touch panel memory and
ENTER
close the keypad.

Power up page

Press the POWER UP PAGE button to open the PAGE menu (Figure 99).
ViewPoint Wireless Touch Panels