Reports From Pipette Calibration Processes - RADWAG UYA 3Y User Manual

List of parameters defined on a pipette:
1. Name
2. Code
3. Model
4. Tip
5. Type of volume
6. Nominal volume
7. Minimal volume
8. Number of channels
9. Type
10. Tested volumes

27.13. Reports from pipette calibration processes

Reports contain data on completed pipette calibration processes. In case of
multichannel pipettes, the reports are generated for each channel separately.
Each report can be previewed, searched by date, exported or printed.
Procedure
Enter submenu <
•
calibration processes >
Press field of a desired report record, unless it is visible on the top of the
•
list, wind the list forward using navigating keys
Report's name consists of date and time of its creation,
•
e.g.: 2012.03.12 11:12:15
Caution:
It is possible to use an option for searching a report.
List of parameters in a report from pipette calibration process:
1. Pipette
2. Serial no.
3. Channel no.
4. Start date
5. End date
6. User
7. Client
8. Number of measurements
9. Operation with ISO 8655
10. Status
11. Temperature [average temperature value during calibration
12. Humidity
13. Pressure
14. Water temperature
15. Z coefficient [value if the Z coefficient for given temperature]
Databases>, and press <
[name from the database of pipettes]
[serial no. inserted during calibration process]
[name of a user carrying out calibration]
[client name]
[no. of measurements for each tested
volume]
[information if errors comply with the
standard]
[information whether the errors are below permissible
value accepted for the tested volume]
process]
[average humidity value during calibration process]
[average pressure value during calibration process]
[average water temperature during
calibration process]
- 142 -
Reports from pipette