Non-Destructive Control With Average Tare Mode - RADWAG UYA 3Y User Manual

Activating average tare determining mode
−
Before starting control type "non-destructive with average tare" the balance
user can determine the average tare value by weighing the packages.
For that purpose enable <
Procedure:
Select parameter:
where:
No -
Yes -
Declaring number of packages
If the < Average tare determining> mode is enabled, then before starting
"non-destructive with average tare" control, the user should also declare
number of packages used for determining the average tare value.
Caution:
The smallest possible quantity for determining the average tare value of
packages is 10 pieces.
Procedure:
Select parameter:
<Quantity of packages> with a numeric keyboard.
Enter required quantity of packages and accept by pressing
For the other settings follow the principle given in point 10.8 of this user
−
manual "Additional parameters on weighing process".

26.3. Non-destructive control with average tare mode

Before control start select a product from the database of products by pressing a
quick access key <
control process.
In order to start control process press
display. The software automatically displays a window with numeric keyboard for
entering the batch number of controlled product. After entering and accepting
the number the software proceeds to the following steps of the CPG process.
If the < Average tare determining> mode is enabled, then before starting
product control it is necessary to determine average packaging mass using at
least 10 pieces of the packaging (number of packages for the control is
determined by the user).
Average tare determining> mode:
" Average tare determining" and set appropriate option.
Average tare determining mode disabled
Average tare determining mode enabled
" Quantity of packages" which opens an editing field
Product>. On selecting the balance is ready to start
key visible in the bottom bar of the
- 127 -
key.