Balances Xa 3Y; Xa 3Y.a - RADWAG UYA 3Y User Manual

2.2.

Balances XA 3Y; XA 3Y.A

Balances XA 3Y.F
CAUTION!
Any activities have to be carried out very carefully and gently not to
damage the measuring system of the balance.
XA 3Y analytic balances
A – balance with d=0,01mg unit
B – balance with d=0,1mg unit
After balance installing at operating place,
following should be set:
1 – bottom ring
2 – balance pan
3 – pan shield
After the elements setting, additional
devices should be connected and balance
should be plugged to power source. Power
socket is located on back side of balance
housing.
Pipettes calibration
Remove the pan and put on its place:
- pipettes calibration chamber
- inside the chamber, pan and other
elements should be set up.
After placing the balance in its intended
place of use, assembly all of its standard
components:
- bottom shield of the weighing
chamber (4)
- bottom ring (3)
- standard weighing pan (1)
- pan shield (2)
After assembling all of the components and
connecting peripheral devices plug the
balance to power source using a dedicated
power adapter. Power socket is located on
back side of balance housing.
Before weighing filters remove the pan
shield (2), the standard weighing pan (1)
and the bottom ring (3). Next, inside the
weighing chamber place a glass shield (6)
and assembly a pan-stand for weighing
filters (5).
on completing the above process zero/tare
balance indication. The system is ready
weighing filters procedures.
- 11 -