Controls - RADWAG UYA 3Y User Manual

Procedure
Enter submenu <
•
key
Press field of a desired report record, unless it is visible on the top of the
•
list, wind the list forward using navigating keys
Report's name consists of date and time of its creation, e.g.:
•
2011.12.12 11:12:15
Caution:
It is possible to use an option for searching a report from density.
List of parameters in a report from density:
1. Sample number, field with a value if in Density mode option: Request
sample number is set = YES
2. Start date
3. End date
4. Density
5. Volume
6. Procedure
7. User
8. Product
9. Standard liquid
10. Standard liquid density
11. Temperature
12. Plunger volume
13. Mass of steel standard
14. Mass of aluminum standard
15. Density of steel standard
16. Density of aluminum standard [density determination of air]
17. Weighing 1
18. Weighing 2

27.10. Controls

Each product control carried out on a balance is sent to a connected printer and
saved in the <
features its specific number set at the moment of its completion.
Databases>, and press <
[calculated density of a sample of solid, liquid or
air]
[calculated volume of tested sample, density
measurement of solid object]
[depending on selected procedure, data contained
in a report may change]
[name of a user carrying out the procedure]
[name of tested sample]
[name of liquid used for determining density
measurement of solid object]
[temperature of liquid used for carrying out a
measurement, density determination of solid
object]
[mass measurement of tested sample or a
plunger in the air, or mass of measured steel
standard]
[mass measurement of tested sample or a
plunger in liquid, or mass of measured aluminum
standard]
Controls> database. Each control saved in the database
[density determination of solid object]
[density determination of liquid]
[density determination of air]
[density determination of air]
[density determination of air]
(not available in standard balance version)
- 139 -
Reports from density>