Muting A Call; Playing A Caller's Name; Disconnecting A Call While Staying On The Phone; Entering An Account Code For A Call - Toshiba Strata CS User Manual

Muting a call

With Strata CS you can mute a call even if your phone does not have a mute button. When
muted, you can hear the caller, but the caller cannot hear you.
To mute a call, choose

Playing a caller's name

You can play a recording of a caller's name over your speakers at any time during a call by
choosing
The recording that plays is either the caller's voice title, if one has been recorded, or the caller's
answer to the call announcing prompt, "Please say your name." If you choose
Announce Caller
the call announcing prompt turned off, or the caller did not answer the prompt.
See "Customizing or turning off call announcing" on page 18-6 for more about call announcing.
See "Recording your voice title" on page 2-2 for more about voice titles.
You can also have the caller's name play automatically when an incoming call arrives. See
"Other options for incoming calls" on page 11-18.

Disconnecting a call while staying on the phone

You can disconnect a call without hanging up the phone. Select the call, and then choose
Actions > Disconnect
This command is useful if:
You want to disconnect a single party in a conference call. Hanging up your phone
!
would disconnect you from the whole conference.
You are going to immediately dial another call. If you hang up and pick up your phone
!
too quickly, Strata CS can read that as a Flash command, which would put the call on
hold instead of disconnecting it.

Entering an account code for a call

While on a call, you can enter an account code for the call or change the one already entered.
1.
2.
3.
You can also enter an account code using the telephone commands. See "Entering an account
code for a call" on page 4-11. In addition, you can enter an account code from the Call Log after
the call is complete. See "Entering an account code for a Call Log entry" on page 14-8.
11-16
Actions > Mute
Actions > Announce Caller
and hear nothing, then either the caller has no voice title recorded, you have
. This command disconnects the caller and provides you with a dial tone.
Select the call, and then choose
Enter an account code.
Click OK .
. Choose
Actions > Mute
.
Actions > Enter Account Code
again to turn muting off.
Actions >
.