Using Eyebeam With Strata Cs - Toshiba Strata CS User Manual

Using eyeBeam with Strata CS _____________________________

This following table describes how eyeBeam features interact with Strata CS.
Feature
Dialing a number
Note: When placing a Strata CS call that requires dialing an access code from an eyeBeam phone,
you do not hear dial tone after dialing the access code. You can continue dialing the number and the
call will be placed correctly. Or, to hear dial tone, you can press the Dial button again after dialing the
access code—for example, Dial, 9, Dial—and then dial the number.
Ending a call
Do Not Disturb
Auto Answer
Auto conferencing
A G. U
PPENDIX SING THE EYE
Directions
Dial numbers just as you would from a Strata CS
phone, including access codes to place external calls.
You can dial Strata CS extensions or access the
telephone commands without an access code.
Note that if the eyeBeam phone is set up as a Strata
CS external station, you cannot dial SIP addresses
from it.
Place a call by clicking the Dial icon:
You can either dial the number first, then click the
icon, or click the icon first, then dial the number.
To end a call, click the End Call icon:
Click the phone's DND button to turn on the Do Not
Disturb Strata CS personal status.
Click the phone's AA button to turn on automatic
answering of incoming calls, similar to Strata CS's
hands-free answering.
You can use Strata CS call screening in combination
with the eyeBeam auto answer feature.
Not supported with Strata CS. Use Strata CS
commands to create conference calls (see "Creating
conference calls" on page 12-12).
B SIP
EAM SOFTPHONE
G-7